Fisher Transform

The Fisher Transform transfigures price into a Gaussian normal distribution. The indicator is typically used to identify “overbought” and “oversold” market conditions and thus is designed to ascertain potential reversal points in the market.

Price is transformed into a normal distribution – commonly referred to as a “bell curve” – where the tail ends of the distribution are thin (namely, the probability of them occurring is theoretically low). This means large swings or extreme values in the indicator should be uncommon.

Therefore, when this does occur, it may be taken as an indication that a price reversal could be in store. For this reason, traders often value the Fisher Transform for its ability to identify potential price reversals in real time rather than the signals generated by lagging indicators. The sharper, more distinct peaks of the indicator unambiguously portray these signals.

fisher transform

Accordingly, it can make for more efficient mechanical trading decisions for those who choose to go that route in their trading.

The Fisher Transform can also be applied to other technical indicators such as the moving average convergence divergence (MACD) and relative strength index (RSI) as an attempt to enhance the predictive capacity of reversals in these indicators.

However, most charting software has the Fisher Transform built-in for price only.

Calculation of the Fisher Transform

The Fisher Transform is calculated as:

Fisher Transform = ½ * ln [(1 + X) / (1 – X)]

Where:

ln denotes the shorthand form of the natural logarithm.

X represents the transformation of price to a level between -1 and 1 for ease of calculation

Trade Examples of the Fisher Transform

Fisher Transform signals can come in the form of a touch or breach of a certain level. For those who take this approach, the thinking is that if one waits for evidence that the indicator has peaked, one has likely missed any potential reversal in price in the asset itself. What this particular level happens to be will be dependent on the market being traded, the timeframe to which the indicator is applied, and is up to the discretion of the trader.

Or prospective trade signals can come from a reversal in the indicator itself. Instead of abiding by a certain breach of a level, one could simply take a trade after the Fisher Transform changes direction. Ideally, like all indicators, this signal wouldn’t be traded in isolation, but due to a confluence of supportive factors, such as the alignment of other technical indicators, price and candlestick patterns, and/or fundamental analysis.

We will look at how the indicator would have worked on a daily chart of the S&P 500.

We’ll take trade signals based on the following rules:

Long trades

  1. Fisher Transform must be negative (i.e., the more negative the indicator is, the more “stretched” or excessively bearish price is)
  2. Taken after a reversal of the Fisher Transform from negatively sloped to positively sloped (i.e., rate of change from negative to positive)

Short trades

  1. Fisher Transform must be positive (i.e., price perceived to be excessively bullish)
  2. Taken after a reversal in the direction of the Fisher Transform

But as we can see below, if we use the indicator in isolation on this particular market – the S&P 500 mapped onto a daily chart – it doesn’t work that well.

Buy (“long”) and sell (“short”) trades are marked between the white vertical lines. The close of the candle marked by the white line to the left marks the opening of a trade while the close of the candle denoted by the white line on the right marks the exit of a trade.

fisher transform

This would have produced four winners and four losers and roughly broken even profit-wise.

If we revise the system to include the rules above but this time take trades only in the direction of the prevailing trend – as dictated by a 50-period moving average – we see greater accuracy.

fisher transform indicator

The first trade is a loser. The second roughly breaks even. The third and fourth are winners.

Other indicators can of course be added to the system as the individual trader sees fit.

Criticism of the Fisher Transform

Financial data tends to be a poor fit for the normal distribution. Some markets, such as developed market equities, tend to be directional and go up over time to reflect the cash-producing nature of corporations. (Stocks represent ownership in a company and are designed to reflect the value of the cash flow returned to owners of the company over time.)

Normal distributions are symmetrical around the mean.